Ismael -PM-40 min -Adding another sensor

Next step

• change code on the arduino to add another sensor 
• we test the code to see if it work
• then change the code to a mega arduino

what Ismael did today:

• I change the code for the arduino
• I change the variable distance by adding a 1
• and the code work

what Nicholas did today:

• He change the code for the arduino
• He change the variable distance by adding a 1
• and he change the wires

Ismael- PM- 60 min- 3D printing the ultrasonic bracket

Next step:

• print the ultrasonic sensor bracket to hold
• put the ultrasonic sensor down
• change the code to greater than 10

   
What Nicholas did today:

• He fix the code to make the tank cars go slow
• He increase the wires 
• hot clue the pop sickle stick to put the sensor down

What Ismael did today:

• I change the speed code to make the tank cars slow
• I use the 3D printer to print ultrasonic sensor
• i find the wires for the sensor

Nicholas-PM- 40 min- Changing the code

Next step:

1. Change the delay time in the code
2. Find a way to share our code

What Nicholas did today:

• I change the code to make it stop at a distance.
• Then we tested it to make sure it works.

What Ismael did today:

• He changed the code to change the distance.
• The he tested the code with the tank car.

Nicholas-PM- 50 min- Creating the code

Next step:

1. Change the distance in the code.
2. Change the time of delay in the code.
3. Find a way to share code.

What Nicholas did today:

• I taped the battery to the board.

what i did in robot club is that we change the code to drive backwords so that way it don't hit

what i did for robot club is i did the zim challenge code and our tank need two batteries so it can work.

Nicholas- PM- 90 min- Making it work

Next Step:

1. Create a code to escape.
2. Add the code into the tank car.
3. Find a way to share code.

What Nicholas did today:

•  I replaced the long wires with short wires because the longer wires were getting in the way and keep getting tangled.
• I added another battery onto the arduino.
• Then connect the ground from the arduino.

Sites:

• https://www.analogictips.com/tips-electrical-noise-reduction-faq/